11、出现提示：
　　
　　q Host Name qqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqq
qqqqqqqqqqqqqqqqqqq
　　
　　On this screen you must enter your host name, which identifies this system
　　on the network. The name must be unique within your domain; creating a
　　duplicate host name will cause problems on the network after you install
　　Solaris.
　　
　　A host name must be at least two characters; it can contain letters, digits,
　　and minus signs (-).
　　
　　
　　Host name:rac1
　　
　　qqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqq
qqqqqqqqqqqqqqqqqqqqqqqqqqqqqqq
　　F2_Continue F6_Help
　　输入主机名，本例中，我们输入主机名rac1后按F2键继续安装；
　　
　　12、出现提示：
　　
　　q IP Address qqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqq
qqqqqqqqqqqqqqqqqq
　　
　　On this screen you must enter the Internet Protocol (IP) address for this
　　system. It must be unique and follow your site''s address conventions, or a
　　system/network failure could result.
　　
　　IP addresses contain four sets of numbers separated by periods (for example
　　129.200.9.1).
　　
　　
　　IP address:192.168.0.1
　　
　　qqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqq
qqqqqqqqqqqqqqqqqqqqqqqqqqqq
　　F2_Continue F6_Help
　　
　　提示输入主机的IP地址，本例中，输入192.168.0.1后按F2键继续安装；
　　
　　13、出现提示：
　　q Subnets qqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqq
qqqqqqqqqqqqqqqq
　　
　　On this screen you must specify whether this system is part of a subnet. If
　　you specify incorrectly, the system will have problems communicating on the
　　network after you reboot.
　　
　　> To make a selection, use the arrow keys to highlight the option and
　　press Return to mark it [X].
　　
　　
　　System part of a subnet
　　qqqqqqqqqqqqqqqqqqqqqqq
　　[X] Yes
　　[ ] No
　　
　　qqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqq
qqqqqqqqqqqqqqqqqqqqqqqqqqqqqq
　　F2_Continue F6_Help
　　提示主机的网络是否采用子网掩码的方法，本例中，要采用子网掩码的方法，因此按F2键继续安装；
　　
　　14、出现提示：
　　q Netmask qqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqq
qqqqqqqqqqqqqqqqqqqq
　　
　　On this screen you must specify the netmask of your subnet. A default
　　netmask is shown; do not accept the default unless you are sure it is
　　correct for your subnet. A netmask must contain four sets of numbers
　　separated by periods (for example 255.255.255.0).
　　
　　
　　Netmask: 255.255.255.0
　　
　　qqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqq
qqqqqqqqqqqqqqqqqqqqqqqqqq
　　F2_Continue F6_Help
　　提示你输入主机的子网掩码，本例中，输入255.255.255.0后，按F2键继续安装；
　　
　　15、出现提示：
　　
　　q IPv6 qqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqq
qqqqqqqqqqqqqqqqqqqq
　　
　　On this screen you should specify whether or not IPv6, the next generation
　　Internet Protocol, will be enabled on this machine. Enabling IPv6 will have
　　no effect if this machine is not on a network that provides IPv6 service.
　　IPv4 service will not be affected if IPv6 is enabled.
　　
　　> To make a selection, use the arrow keys to highlight the option and
　　press Return to mark it [X].
　　
　　
　　Enable IPv6
　　qqqqqqqqqqq
　　[ ] Yes
　　[X] No
　　
　　
　　
　　qqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqq
qqqqqqqqqqqqqqqqqqqqqqqqqq
　　F2_Continue F6_Help
　　提示你是否采用IPv6技术？本例中，不采用IPv6技术，按F2键继续安装；